Discovered by Player FM and our community — copyright is owned by the publisher, not Player FM, and audio is streamed directly from their servers. Cet article ne cite pas suffisamment ses sources mai Si vous disposez d'ouvrages ou

Nom: orcad family release 9.2 lite edition
Format:Fichier D’archive
Licence:Usage personnel seulement (acheter plus tard!)
Système d’exploitation: Android. iOS. MacOS. Windows XP/7/10.
Taille:25.15 Megabytes

This will now allow you to actually draw a circuit with electronic components that can be individually adjusted for their properties. We are ready to begin designing. First, the Ground potential reference point is a circuit node or in the Place menu.

We want to Place this node in our circuit.

Résumé du cours

So, you may reach this by pointing to the Place menu. Now, click on Ground, and you will see the Ground dialog box.

Click on the Add Library button and select the source library from the PSpice folder. After returning to the dialog box you should see the Libraries highlighted as shown. Then, click on OK and you will now find that there is a Ground symbol attached to your mouse Cursor.

Place this by clicking with the left mouse button. Then, click with the right mouse button. If you are not careful here, you will accidentally create 3 two ground terminals one will have to be deleted by right clicking on the part and deleting it. Now, we will add a conductor Wire to our circuit.

Again, proceed to the Place menu, select Wire, and this will now create a drawing tool. You may create the wire by placing the mouse cursor on the terminal at the top of the Ground symbol and then holding down the left mouse button while dragging the mouse cursor upwards as you can see this is the standard Windows drawing paradigm so this will be familiar to you.

Now, we must start to add Resistor and Source components. To obtain and Place these parts we again navigate to the Place menu. But, this time, click on Part. This will bring up a Place Part dialog box.

At this stage, we need to add Parts Libraries to our list of choices.

orcad release 9.2 download

You will need to perform this only once, in the future, the Libraries will appear by default. Click on Add Libraries and select all the libraries listed in the PSpice folder. Now, we can add a Resistor to our circuit. This will bring up a list of parts in the Part List box. Now, scroll down to R and click on this.

Click the OK button to select this and then you are ready to Place this part.

Proceed to place this part as shown in Figure 4. To place a power source, follow the same steps as above, but remember to search for VDC in the Parts dialog box. To change the value of a part, double click on the number representing the value, and enter the required magnitude in the value field.

Draw the circuit show in Figure 5 in PSpice. Now, with our circuit complete, we are ready to start a Simulation. First, we must configure the Simulation tool.

Name your simulation and leave the inherit from field to none. When ready click Create. This will bring up the Simulation Settings Dialog Box. Now, the Analysis type we must select is Bias Point. You can reach this by scrolling through the Analysis type selections and clicking on Bias Point. Le premier pas pour obtenir une de ces plaques de circuit imprimé ou PCB Printed Circuit Boards est la réalisation du design, pour utiliser les outils spécifiques qui existent dans le marché.

OrCAD est un des plus populaires.

Lab No 02 Elect II Intro to PSpice EE221 for BEE2C BICSE8

OrCAD est l'outil de plus puissant et intuitif pour le design de circuits électroniques imprimés. À grands traits, les pas à suivre pour dessiner une plaque de circuit imprimé sont les suivants : Dessinez le circuit avec la création d'un schéma électrique dans le module "Capture".

Placez les composants et tracez les pistes. Générez les fichiers du design.